Installation guide

5 – Windows 2000 Driver Installation QL2200IP NDIS Network Driver Installation
FC0153302-00 F 5-5
14. Select Network & Dial-up Connections in the Control Panel.
15. Right-click the Local Area Connection icon, then select Properties.
NOTE: If your system has multiple Local Area Connection icons, select the
most recent (highest number listed).
16. Make sure the QLA2200 PCI Adapter is listed under Connect using.
17. Click Internet Protocol (TCP/IP), then select Properties. The TCP/IP
Properties dialog box is displayed.
18. Specify an IP address and subnet mask for each adapter on the network.
Each IP address must be unique and all adapters must use the same subnet
mask. For example:
Adapter 1
IP address: 10.0.0.1
Subnet mask: 255.255.0.0
Adapter 2
IP address: 10.0.0.2
Subnet mask: 255.255.0.0
19. Click OK to close the TCP/IP Properties dialog box.
20. Click OK.
5.5.2
Updating the QL2200IP NDIS Network Driver
Perform the following steps if a QL2200IP NDIS network driver is already installed
and you want to install an updated version of the driver.
1. Open a DOS command prompt window.
2. Change the current directory to the Windows 2000 driver directory. For
example:
CD \WINNT\SYSTEM32\DRIVERS
3. Make a backup copy of the old driver. You can copy the file into the same
directory with a .SAV extension indicating that it is the saved file. For
example:
COPY QL2200IP.SYS QL2200IP.SAV
4. Insert the disk that contains the updated QLogic driver into an appropriate
drive.
5. Copy the new driver over the old driver. For example:
COPY A:\W2K\IP\QL2200IP.SYS
6. Remove the disk that contains the QLogic driver.
7. Reboot your system to load the updated driver.