Installation guide

QL2200IP NDIS Network Driver Installation 5 – Windows 2000 Driver Installation
5-4 FC0153302-00 F
See appendix A for further information.
5.5
QL2200IP NDIS Network Driver Installation
Your system must meet the following requirements for the QL2200IP network driver
interface specification (NDIS) network driver to function properly.
■ The QL2200 Enhanced + IP SCSI miniport driver must be installed.
■ The Fast!Util Drivers Load RISC Code adapter parameter must be enabled
(refer to the Hardware Installation Guide for the QLA2200 Board Family
[FC0151103-00]).
■ Windows 2000 networking software must be installed.
■ All adapters on the network must have the same value set for the maximum
transfer unit (MTU) size (IP configuration parameter).
If a QL2200IP NDIS network driver is not installed on your system, perform the
installation procedures in section 5.5.1. If an older QL2200IP network driver is
already installed on your system, perform the update procedures in section 5.5.2.
5.5.1
Initial Installation of the QL2200IP NDIS Network Driver
Perform the following steps to install the QL2200IP NDIS network driver.
1. Click the Start button, point to Settings, then click Control Panel.
2. Select System.
3. Select the Hardware tab, then click Hardware Wizard.
4. Select the Add/Troubleshoot a device option.
5. Select Add a new device.
6. Select the No, I want to select the hardware from a list option.
7. Select Network Adapters.
8. Insert the disk that contains the QLogic driver into an appropriate drive and
click Have Disk.
9. Type the path to the QL2200IP NDIS network driver. For example:
CAUTION!
A:\W2K\IP
10. Click OK.
11. Select the QLogic QL2200IP Network Driver, then click Next.
12. Click Finish to complete the driver installation.
13. Click OK to close the System dialog box.