Installation guide

Windows 2000 Installation 5 Windows 2000 Driver Installation
5-2 FC0153302-00 F
3. Follow the standard Windows 2000 installation instructions.
4. Press F6 to Install Additional Devices.
5. Press s to specify an additional device.
6. Insert the disk that contains the QLogic driver into an appropriate drive, then
press ENTER.
7. Windows 2000 detects the QLogic QLA2200 PCI Fibre Channel Adapter.
Press ENTER to continue the driver installation.
8. Press ENTER to continue the Windows 2000 installation.
9. Follow the instructions on the screen to complete the Windows 2000
installation.
5.3.2
Installing the Windows 2000 Driver
The QLA2xx boards are plug-and-play devices that are automatically detected by
Windows 2000. Perform the following steps to add the Windows 2000 driver to a
previously installed Windows 2000 system.
1. Install the QLA22xx board.
2. Power up the computer. Windows 2000 detects the QLA22xx and starts the
Found New Hardware Wizard.
3. Click Next.
4. Select Search for a suitable driver for my device (Recommended). Click
Next.
5. Select SCSI and RAID controllers in the Hardware Types list, then click
Next.
6. Click Have Disk. The Install From Disk dialog box displays.
7. Insert the disk that contains the QLogic driver into an appropriate drive, then
type the location of the Windows 2000 driver. For example:
A:\W2K
8. Click OK.
9. Select QLogic QLA2200 PCI Fibre Channel Adapter, then click Next.
Windows 2000 indicates that the wizard is ready to install the device.
10. Click Next.
11. If the Digital Signature Not Found dialog box appears, click Yes.
12. Click Finish.
13. Remove the disk that contains the QLogic driver from the drive, then click
Yes to restart the system.