Installation guide

4 – Windows NT Driver Installation QL2200IP NDIS Network Driver Installation
FC0153302-00 F 4-5
11. Specify an IP address and subnet mask for each adapter on the network.
Each IP address must be unique and all adapters must use the same subnet
mask. For example:
Adapter 1
IP address: 10.0.0.1
Subnet mask: 255.255.0.0
Adapter 2
IP address: 10.0.0.2
Subnet mask: 255.255.0.0
12. Click OK.
13. Remove the disk and click Yes to restart the computer.
4.5.2
Updating the QL2200IP NDIS Network Driver
Perform the following steps if a QL2200IP NDIS network driver is already installed
and you want to install an updated version of the driver.
1. Open a DOS command prompt window.
2. Change the current directory to the Windows NT driver directory. For
example:
CD \WINNT\SYSTEM32\DRIVERS
3. Make a backup copy of the old driver. You can copy the file into the same
directory with a .SAV extension indicating that it is the saved file. For
example:
COPY QL2200IP.SYS QL2200IP.SAV
4. Insert the disk that contains the updated QLogic driver into an appropriate
drive.
5. Copy the new driver over the old driver. For example:
COPY A:\NT\IP\QL2200IP.SYS
6. Remove the disk that contains the QLogic driver.
7. Reboot your computer to load the updated driver.