Installation guide

QL2200IP NDIS Network Driver Installation 4 – Windows NT Driver Installation
4-4 FC0153302-00 F
4.5
QL2200IP NDIS Network Driver Installation
Your system must meet the following requirements for the QL2200IP network driver
interface specification (NDIS) network driver to function properly.
■ The QL2200 Enhanced + IP SCSI miniport driver must be installed.
■ The Fast!Util Drivers Load RISC Code adapter parameter must be enabled
(refer to the Hardware Installation Guide for the QLA2200 Board Family
[FC0151103-00]).
■ Windows NT networking software must be installed.
■ All adapters on the network must have the same value set for the maximum
transfer unit (MTU) size (IP configuration parameter).
If a QL2200IP NDIS network driver is not installed on your system, perform the
installation procedures in section 4.5.1. If an older QL2200IP network driver is
already installed on your system, perform the update procedures in section 4.5.2.
4.5.1
Initial Installation of the QL2200IP NDIS Network Driver
Perform the following steps to install the QL2200IP NDIS network driver.
1. Select My Computer from the desktop.
2. Select Control Panel.
3. Select Network.
4. Select the Adapters tab and click Add.
5. Insert the disk that contains the QLogic driver into an appropriate drive and
click Have Disk.
6. Type the path to the QL2200IP NDIS network driver. For example:
A:\NT\IP
7. Click OK.
8. Select the QLogic QL2200IP Network Driver, then click OK. The
QL2200IP Configuration Utility dialog box opens.
9. Check that the MTU Size is set to the same value that is used on the other
adapters on the network, then click OK.
10. Click Close. The TCP/IP Properties dialog box is displayed.