Installation guide

Windows NT Installation 4 – Windows NT Driver Installation
4-2 FC0153302-00 F
4.3.1
Initial Installation of Windows NT and the Windows NT Driver
Perform the following steps to install Windows NT 4.0 on the Fibre Channel hard
disk attached to the QLA22xx board.
1. Insert the Windows NT setup disk or CD (if booting from a bootable CD-ROM
drive) in an appropriate drive.
2. Reboot your system.
3. Press F6 to Install Additional Devices.
4. Press s to specify an additional device.
5. Select Other, then press ENTER.
6. Insert the disk that contains the QLogic driver into an appropriate drive, then
press ENTER.
7. Select QLogic QLA2200 PCI Fibre Channel Adapter, then press ENTER.
8. Follow the standard Windows NT installation instructions to complete the
Windows NT setup.
4.3.2
Installing or Updating the Windows NT Driver
Perform the following steps to add the Windows NT driver to a previously installed
Windows NT 4.0 system.
NOTE: This procedure restores the default registry parameters for the QLA22xx
Windows NT driver.
1. Select My Computer from the desktop.
2. Select Control Panel.
3. Select SCSI Adapters.
4. Select the Drivers tab and click Add.
5. Insert the disk that contains the QLogic driver into an appropriate drive and
click Have Disk.
6. Type the path to the NT driver. For example:
A:\NT
7. Click OK.
8. Select the QLogic QLA2200 PCI Fibre Channel Adapter, then click OK.
9. Remove the disk, then click Yes to restart the computer.