Installation guide

Installing the NetWare Driver 3 – NetWare Driver Installation
3-2 FC0153302-00 F
Perform the following steps to install the NetWare driver in a previously installed
NetWare 4.x or 5.x system.
NOTE: The following procedure modifies your NetWare STARTUP.NCF file to load
the driver automatically when your system boots.
1. Start NetWare and load the NetWare Install program from the NetWare
server prompt (SERVERNAME:).
Type the following command if you are using NetWare 4.x:
LOAD INSTALL
Type the following command if you are using NetWare 5.x:
LOAD NWCONFIG
2. Select Driver options from the main menu.
3. Select Configure disk and storage device drivers.
4. Select Select an additional driver.
5. Press INSERT to install an unlisted driver.
6. Insert the disk that contains the QLogic driver in an appropriate drive.
7. Press ENTER to scan the disk for the QLogic driver.
8. Press ENTER to select the QL2200.HAM driver.
9. If prompted, select Yes to copy the driver.
10. You are prompted for the server directory. Type the path of the server
directory, or press ENTER to accept the default.
11. If necessary, select Select/Modify Driver Parameters to modify the default
settings.
12. Press F10 to save the parameter settings.
13. Select Save parameters and load driver to complete the NetWare setup.
NOTE: If ASPI support is required for the SCSI devices, you must load the
NWASPI.CDM module, which is provided by Novell. For example:
LOAD QL2200.HAM
LOAD NWASPI.CDM