User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 65
1.11.9 Installing Emulex LP8000 adapter cards
This section tells you how to attach an ESS to a Windows 2000 host system with
Emulex LP8000 adapter cards. Single-and dual-port Fibre Channel interfaces
with the Emulex LP8000 adapter cards support the following public and private
loop modes:
򐂰 Tar ge t
򐂰 Public initiator
򐂰 Private initiator
򐂰 Target and public initiator
򐂰 Target and private initiator
The ESS supports increased connectivity with the use of Fibre Channel
(SCSI-FCP and FICON) directors. Specific details on status, availability, and
configuration options for the Fibre Channel directors supported by the ESS are
available on the Web:
www.storage.ibm.com/hardsoft/products/ess/supserver.htm
Perform the following steps to install the Emulex LP8000 adapter card:
1. Turn off and unplug the computer.
2. Remove the computer case.
3. Remove the blank menu from an empty PCI bus slot.
4. Insert the host adapter board into the empty PCI bus slot. Press firmly until
seated.
5. Secure the mounting bracket for the adapter to the case with the panel screw.
6. Replace the computer case by tightening the screws on the case, or use the
clamp to secure the cover.
1.11.10 Downloading the current Fibre Channel adapter driver
This section tells you how to install the port driver.
1. Plug in and restart your host system.
2. Go to the following Web site:
www.emulex.com
3. From the Quick Links menu, click Documentation, Drivers, and Software.
4. Click the host adapter type from the host adapter menu.
5. Click Drivers for Windows 2000.
6. Click Fibre Channel Port v5-1.27a5.
7. Click the Download Now button.