User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 61
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, select Host Adapter Settings.
6. From the Host Adapter Settings menu, set the following parameters and
values:
a. Host adapter BIOS: Disabled
b. Frame size: 2048
c. Loop reset delay: 5 (minimum)
d. Adapter hard loop ID: Disabled
7. From the Advanced Adapter Settings menu, press the Down Arrow to
highlight LUNs per target. Press Enter. Set the parameters and values from
the Advanced Adapter Settings menu as follows:
a. Execution throttle: 100
b. Fast command posting: Enabled
c. >4 GB addressing: Disabled for 32 bit systems
d. LUNs per target: 0
e. Enable LIP reset: No
f. Enable LIP full login: No
g. Enable target reset: Yes
h. Login retrycount: 20 (minimum)
i. Port down retrycount: 20 ((minimum)
j. Driver load RISC code: Enabled
k. Enable database updates: No
l. Disable database load: No
m. IOCB allocation: 256
n. Extended error logging: Disabled (might be enabled for debugging)
8. Press Esc to return to the Configuration Settings menu.
9. From the Configuration Settings menu, scroll down to Extended Firmware
Settings. Press Enter.
Note: In a clustering environment, set Enable LIP full login to Yes.
Note: The Enable LIP reset, Enable LIP full logon, and Enable target reset
parameters control the behavior of the adapter when Windows NT tries to do a
SCSI bus reset. You must perform a target reset to make cluster failovers
work.Use the SCSI bus device reset option to clear SCSI reservations.