User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 49
Perform the following steps to install the QLogic QLA2100F adapter card:
1. Install the QLogic QLA2100F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the host system.
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, select Host Adapter Settings.
6. From the Advanced Adapter Settings menu, press the Down Arrow to
highlight LUNs per target; then press Enter.
7. Use the Down Arrow to find and highlight 256. Press Enter.
8. Press Esc.
9. To save the changes, click Yes. Press Enter.
10.Restart the server.
1.10.3 Installing the QLogic QLA2200F adapter card
This section tells you how to attach an ESS to a Windows NT host system with
the QLogic QLA2200F adapter card. Single-and dual-port Fibre Channel
interfaces with the QLogic QLA2200F adapter card support the following public
and private loop modes:
򐂰 Tar ge t
򐂰 Public initiator
򐂰 Private initiator
򐂰 Target and public initiator
򐂰 Target and private initiator
Perform the following steps to install the QLogic QLA2200F adapter card:
1. Install the QLogic QLA2200F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the server.
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, select Host Adapter Settings.
6. From the Host Adapter Settings menu, set the following parameters and
values:
a. Host adapter BIOS: Disabled
b. Frame size: 2048
c. Loop reset delay: 5 (minimum)
d. Adapter hard loop ID: Disabled