User`s guide

40 Implementing an Open IBM SAN
2. From the home page, click Driver Download.
3. Click Use QLogic Drivers.
4. Click Fibre Channel Adapter Drivers and Software.
5. In table, click QLA22xx drivers.
6. From the menu for Software and Drivers available for, click Solaris.
7. From the table for QLA22xx Driver Download Page, Solaris Sparc 2.6/2.7/2.8,
and Current released (Sparc) driver PCI to FC Adapter, click Link to Driver.
8. Download the file and save as required.
1.9.13 Installing the Fibre Channel adapter drivers
Perform the following steps to install the Fibre Channel adapter drivers.
1. Go to the following Web site:
www.qlogic.com
2. From the home page, click Driver Download.
3. Click Use Qlogic Drivers button.
4. Click Fibre Channel Adapter Drivers and Software.
5. In the table for Qlogic Fibre Channel Adapters, click QLA22xx.
6. From the menu for Software and Drivers available for, click Solaris.
7. From the table for QLA22xx Driver Download Page, Solaris Sparc 2.6/2.7/2.8,
and Current released (Sparc) driver PCI to FC Adapter, click Read Me.
This action displays the contents of the Read Me file, which contains the
instructions to install the driver file.
8. Update the parameter file if necessary. See Table 1-9 on page 43.
1.9.14 Configuring host device drivers
The following procedures tell you how to update the Solaris SCSI driver
configuration file to enable access to target and LUN pairs configured on the
ESS.
Note: If you are installing the Fibre Channel adapter for the first time, you
must specify the correct topology. You must also select the appropriate device
mapping driver.