User`s guide

36 Implementing an Open IBM SAN
11.If you downloaded the driver file from a Sun host system, go to Installing the
JNI PCI Fibre Channel adapter driver. If you downloaded the driver file from
a non-Sun host system, transfer the drive file to a Sun host system.
1.9.7 Installing the JNI PCI Fibre Channel adapter driver
Perform the following steps to install the JNI PCI Fibre Channel adapter drivers:
1. Go to the following Web site:
www.jni.com
2. From the navigation menu at the top of the page, click Drivers.
3. From the menu for Locate Driver by Product, click FCI-1063.
4. From the menu for FCI-1063, find the section for Solaris -JNI. Click
readme.txt.
5. Print the readme.txt file.
6. Follow the instructions in the readme.txt file to install the JNI PCI adapter
card.
7. Update the parameter list. See Table 1-7 on page 42.
8. Restart the host system.
1.9.8 Installing the JNI SBUS adapter card
This section tells you how to attach an ESS to a Sun host system with the JNI
SBUS adapter card.
Perform the following steps to install the JNI SBUS adapter card:
1. Turn off and unplug the computer.
2. Remove the computer case.
3. Remove the blank panel from an empty SBUS slot.
4. Insert the host adapter board into the empty SBUS slot. Press firmly until
seated.
5. Secure the mounting bracket for the adapter to the case with the panel screw.
6. Replace the computer case by tightening the screws on the case or use the
clamp to secure the cover.