User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 35
18.Update the parameter list. See Table 1-8 on page 42.
19.Restart the host system.
1.9.5 Installing the JNI PCI adapter card
This section tells you how to attach an ESS to a Sun host system with the JNI
PCI adapter card:
1. Perform the following steps to install the JNI PCI adapter card.
2. Turn off and unplug the computer.
3. Remove the computer case.
4. Remove the blank panel from an empty PCI bus slot.
5. Insert the host adapter board into the empty PCI bus slot. Press firmly until
seated.
6. Secure the mounting bracket for the adapter to the case with the panel screw.
7. Replace the computer case by tightening the screws on the case or use the
clamp to secure the cover.
1.9.6 Downloading the current JNI PCI Fibre Channel adapter driver
This section tells you how to download the JNI PCI Fibre Channel adapter driver:
1. Plug in and restart your host system.
2. Go to the following Web site:
www.jni.com
3. From the navigation menu at the top of the page, click Drivers.
4. From the menu for Locate Driver by Product, click FCI-1063.
5. From the menu for FCI-1063, find the section for Solaris -JNI. Click
fca-pci.pkg.
6. In the dialog box for File Download, click Save this file to disk. Click OK.
7. In the Save As dialog box, create a temporary folder.
8. Click Save.
9. When you click Save, a window displays that shows the progress of the
download.
10.When the download completes, click Close.
Note: You must restart your system twice if IP is enabled.