User`s guide

34 Implementing an Open IBM SAN
6. If the file is in the format of filename.tar.Z, type uncompress filename.tar.Z.
7. Type tar xvf lpfc-sparc.tar to “untar” the drive file from the temporary
directory.
8. Type pkgadd -d pwd to install the package.
9. Specify the package number or press Enter to accept all packages.
10.Type y or n to answer the prompt that reads: Rebuild manual pages database
for section 7d [y,n?]:. If you typed y, go to step 11.
11.At the prompt that reads Use IP networking over Fibre Channel [y,n?]: type y
or n. If you typed y, go to step 12.
12.Type the name of the network host name for the adapter.
13.Edit the /etc/hosts file to add the IP address to the host name.
14.At the prompt that reads:
Do you want to continue with the installation of <lpfc>
Ty pe y to proceed with the installation, or type n to undo all the settings and
end the installation.
15.At the prompt that reads:
Select package(s) you wish to process (or ’all’ to process all packages).
(default:all) [?,??,q ]:
Ty pe q.
16.At the system prompt, type shutdown to restart the host system.
17.Login as root.
Note: An installation script displays that prompts you to answer a number of
questions. For each question, enter the appropriate response. Or, press Enter
to each question to accept the default setting.
Note: Rebuilding the manual pages can take up to ten minutes. If you do not
want to build the manual pages, type n.You can run the command later.
Note: The network host name identifies the host adapter on a Fibre Channel
network and is associated with a unique IP address.
Note: If you have more than one adapter in the system, you must create a
hostname.lpfn#file for each adapter.
Note: We recommend that you configure the host adapter parameters before
you shut down and restart the host system.