User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 33
6. Replace the computer case by tightening the screws on the case or use the
clamp to secure the cover.
1.9.3 Downloading the current Emulex Fibre Channel adapter driver
This section tells you how to install the Emulex driver:
1. Plug in and restart your host system.
2. Go to the following Web site:
www.emulex.com
3. From the left navigation menu for Quick Links, click Documentation, Drivers
and Software.
4. From the Fibre Channel menu, select the adapter model.
5. Click Drivers for Solaris.
6. Click SCSI/IP v4.xxx where xxx equals the level of the driver for Solaris.
7. Click Download Now for an Intel driver or Download Now for a SPARC
driver.
8. From the File Download window, click Save this file to disk.
9. Click OK.
10.In the Save As window, click Save.
A window that shows the progress of the download is displayed.
11.When the download completes, click Close.
1.9.4 Installing the Fibre Channel adapter drivers
Perform the following steps to install the Fibre Channel adapter drivers:
1. Login as root.
2. Type emlxtemp to create a temporary directory.
3. Type cd emlxtemp to change the directory to the temporary directory. If you
are downloading the file from the FTP site or have the file on the CD-ROM, go
to step 5.
4. Type /etc/init.d/volmgt stop and then unmount /dev/fd to copy the tar file
from a floppy diskette
5. Copy or download the device driver file to the temporary directory.
Note: If you downloaded the driver file to a host system other than a Sun,
you must transfer the file to the Sun host system. Otherwise, go to
“Installing the Emulex LP8000 Fibre Channel adapter drivers”.