User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 31
򐂰 Solaris 2.6, Solaris 7, and Solaris 8 require patches to ensure that the host
and the ESS function correctly. See Table 1-6 for the minimum revision level
that is required for each Solaris patch ID.
Table 1-6 Solaris 2.6, 7, and 8 minimum revision level patches for Fibre Channel
򐂰 Review the Sun host SCSI adapter device driver installation and configuration
utility documents for additional Solaris patches that you might need.
򐂰 See the following Web site for details about the release level for your
operating system:
www.storage.ibm.com/hardsoft/products/ess/supserver.htm
Either you or an IBM service support representative (SSR) must perform the
following tasks to install and configure an ESS.
1. The IBM SSR installs the ESS by using the procedures in the IBM Enterprise
Storage Server Service Guide
2. Either you or an IBM SSR defines the Fibre Channel host system with the
worldwide port name identifiers.
3. Either you or an IBM SSR defines the Fiber Channel port configuration if you
did not do it during the installation of the ESS or Fibre Channel adapters.
Solaris 2.6 Solaris 7 Solaris 8
105181-23 kernel update 106541-12 kernel update 108528-03 kernel update
105356-16 sd, ssd drivers 106924-06 isp driver 109524-02 ssd driver
105580-16 glm driver 106925-04 glm driver 109657-01 isp driver
105600-19 isp driver 107147-08 pci driver 108974-03 sd, uata drivers
Not applicable 107458-10 dad, sd, ssd,
uata drivers
Not applicable
Note: Use the information on the logical configuration work sheet in the IBM
Enterprise Storage Server Configuration Planner you should have previously
filled out.