User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 29
1.8.3 Loading the current Fibre Channel adapter driver
Perform the following steps to load the current driver onto the QLogic adapter
card.
1. Go to the following Web site:
www.qlc.com
2. From the home page, click Driver Download.
3. Click Drivers.
4. Click Fibre-Channel Adapter Drivers.
5. Click QLA2xxx drivers.
6. Click Novell NetWare.
7. Click QLogic Vx.xxx where V is the version and x.xxx is the version level of
the file name.
8. In the Save As window, find the current driver file, xxxxxxx.exe, where
xxxxxxx is the driver file name.
9. Click Save.
10.Close the Web site.
11.From your host system Start menu, click Run.
12.In the Run window, ensure that the drive letter in the field is the same as the
drive letter where you saved the xxxxxxx.exe file. If no drive letter appears,
type the letter of the drive where you saved the driver file.
13.Type the driver file name after x:, where x is the drive letter you specified to
save the file.
14.Type the directory name where you want to put the file. Click Zip.
15.Click OK to unzip the current driver file.
1.8.4 Installing the Fibre Channel adapter drivers
Perform the following steps to install the Fibre Channel adapter drivers.
1. From the NetWare server console, type nwconfig for NetWare 5.0 or 5.1 or
load install for NetWare 4.x.
2. Select Driver Options.
3. Select Configure Disk and Storage Device Drivers.
4. In the SCSI Adapters window, click the Drivers tab.
Note: We recommend that you save the file to a floppy diskette.