User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 27
6. From the Advanced Adapter Settings menu, press the Down Arrow to
highlight LUNs per target. Press Enter.
7. Press the Down Arrow to find and highlight 256. Press Enter.
8. Press Esc.
9. To save the changes, click Yes. Press Enter.
10.Restart the server.
1.8.2 Installing the QLogic QLA2200F adapter card
This section tells you how to attach an ESS to a Novell NetWare host system
with the QLogic QLA2200F adapter card. Single-and dual port Fibre Channel
interfaces with the QLogic QLA2200F adapter card support the following public
and private loop modes:
򐂰 Tar ge t
򐂰 Public initiator
򐂰 Private initiator
򐂰 Target and public initiator
򐂰 Target and private initiator
Perform the following steps to install the QLogic QLA2200F adapter card:
1. Install the QLogic QLA2200F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the server.
4. Press Alt+Q to get to the FAST!Util Command panel.
5. From the Configuration Settings menu, click Host Adapter Settings and set
the parameters and values from the Host Adapter Settings menu as follows:
a. Host adapter BIOS: Disabled
b. Frame size: 2048
c. Loop reset delay: 5 (minimum)
d. Adapter hard loop ID: Disabled
6. From the Advanced Adapter Settings menu, press the Down Arrow key to
highlight LUNs per target; then press Enter. Set the parameters and values
from the Advanced Adapter Settings menu as follows:
Note: The following steps are an example of a configuration. The
configuration for your adapter might differ.