User`s guide

26 Implementing an Open IBM SAN
3. Extend the volume group to include the c3t0d0 path. When you issue a
vgdisplay -v command on the volume group, it lists c3t0d0 as an alternate
link to the data.
1.8 Novell NetWare FC host system attachment
This topic describes how to attach a Novell NetWare host system to an IBM ESS
with the following adapter cards:
򐂰 QLogic QLA2100F
򐂰 QLogic QLA2200F
1.8.1 Installing the QLogic QLA2100F adapter card
This section tells you how to attach an ESS to a Novell NetWare host system
with the QLogic QLA2100F adapter card.
Single-port Fibre Channel interfaces with the QLogic QLA2100F adapter card
support the following loop modes:
򐂰 Tar ge t
򐂰 Initiator
򐂰 Target and initiator
Perform the following steps to install the QLogic QLA2100F adapter card:
1. Install the QLogic QLA2100F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the server.
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, click Host Adapter Settings.
Note: The IBM SAN Fibre Channel Switch 2109 S08 and IBM SAN Fibre
Channel Switch 2109 S16 are supported for Novell NetWare. The IBM SAN
Data Gateway 2108 Model G07 is not supported for Novell NetWare.
Note: The arbitrated loop topology is the only topology available for the
QLogic QLA2100F adapter card.
Note: The following steps are an example of a configuration. The
configuration for your adapter might differ.