User`s guide

Chapter 5. Implementing the Vicom Fibre Channel SLIC Router 357
In the Mirror Drive window, you can see the new mirror drive that was created
above and named CompMir. In the Composite Drive window you can see that
there are still the two composite drives, but instead of having Fibre Channel LUN
numbers assigned to them, they are shown as belonging to a mirror with the
name CompMir.
You can highlight the CompMir drive and click the Properties button. All the
same functions that were described in 5.6.2, “Mirror drive properties” on
page 346 are available.
5.9 Reusing logical drives
At some point the composite, mirror, and instant copy logical drives that have
created may be no longer required. The logical drive can be removed so that the
member drives that made up the logical drive can then be used individually or
reconfigured to make new logical drives.
5.9.1 Remove a logical drive
To remove a logical drive, you access the Control Center by selecting Tools ->
Control Center from the top toolbar. At the Control Center window, select the
logical drive (composite, mirror, or copy) that you want to remove. Select the
Remove Logical Drive button on the right hand side and a dialog box appears
that will ask you to confirm that you want to remove the logical drive.
Once it is removed, the member drives will become general spares and will show
up in the General Spare Drive window of the Control Center. This is shown in
Figure 5-35.