User`s guide

348 Implementing an Open IBM SAN
5.7.1 Creating an Instant Copy drive
To create an Instant Copy drive, select Tools -> Instant Copy Drive Setup
Wizard. You will see a dialog box, Instant Copy Drive List, that will be blank. If
there were copy drives created, it would display the names of the drives. Click the
Next>> button and the Instant Copy Drive Members Selection window is
displayed. The window on the left named Available Drive Pool contains a list off
all drives that are candidates to become a copy drive.
Select a drive by highlighting it and click the Add>> button. The drive name will
be added to the Member window. An asterisk will appear on the left hand side of
the drive just selected in the Available Drive window to denote that the drive has
been selected. An example is shown in Figure 5-25.
Figure 5-25 Instant Copy Drive Member Selection
To remove a drive from the Member window, select the desired drive and click the
Remove<< button. Below each window there is a Drive Capacity box. As a drive
is selected, its capacity in megabytes is shown. Click the Next> button to
continue to the Assigning Instant Copy Drive Properties window, as shown in
Figure 5-26.