User`s guide

Chapter 5. Implementing the Vicom Fibre Channel SLIC Router 331
Installing the SLIC Manager daemon
With the configuration file edited and a SLIC Zone created, the daemon service
can be installed and run. To install the service in Windows NT, open a DOS
prompt and go to C:\ibm7190\sdus. Type in slicd -install, and the daemon
will be installed.
Starting the SLIC Manager daemon
To start the daemon service, select Start -> Settings -> Control panel from
Windows NT. Double-click the Services icon. Scroll down until you see Vicom
SLIC Manager; select and highlight it. You will see two columns to the right to
indicate its status.
To start the service, click the Start button and it will take a few moments to
complete. Once it is done, you will see the word Started in the Status column.
If the Startup column contains the word Automatic, no further action is
required. If not, click the Startup button, and change the Startup Type to
Automatic. This will have the daemon service start automatically during a reboot.
This is shown in Figure 5-6.
Figure 5-6 SLIC daemon start up in Windows NT