User`s guide

308 Implementing an Open IBM SAN
Figure 4-40 Fibre Channel port setting for switch attachment
By default, the setting in the Connection Options box will have Loop enabled.
For switch or fabric connection, select Point to Point, and then select OK. The
SAN Data Gateway must be restarted for the change to take effect.
A Fibre Channel cable can be connected from the switch to the port on the
Gateway. The data to the Specialist must be refreshed by selecting and
highlighting the Gateway and then select View -> Refresh SAN Data Gateway.
Note: Connection Options box does not appear, the Fibre Channel module
installed will support loop connection only and will not support fabric
connection. The module must be replaced or select a port that will support
fabric connection.