User`s guide

Chapter 1. Implementing Fibre Channel host adapter cards 17
1. Insert the Service Pack 3 compact disc into the CD-ROM or CD-R drive.
2. Open the README file for instructions on installing Service Pack 3.
In Table 1-5 we show the NUMA-Q system requirements. Support for Copy
Services on PTX V4.5.2 requires a special Technology Pack. You can obtain the
Technology Pack through an IBM sales representative who handles your xSeries
and NUMA-Q purchases.
Table 1-5 xSeries and NUMA-Q system requirements for the ESS
1.5.3 Installing the IOC-0210-54 adapter card
Perform the following steps to install the IOC-0210-54 adapter card:
1. Contact your IBM SSR to install the IOC-0210-54 adapter card in the ESS.
2. Connect the cable to the ESS port.
The SSR establishes the private LAN connection between both clusters on
the ESS, the Ethernet hub, and the ESS personal computer console.
Preconfigured multimode optical cables are available to connect the ESS to
the NUMA-Q host system. The 8m (24-ft) cable might be required. The way
you connect the cable to the ESS through the Fibre Channel switch depends
on the level of I/O throughput.
For information about connection schemes, see the Fibre Channel
Subsystems Installation Guide at the following Web site:
techdocs.sequent.com/staticpath/shsvccd/start.htm
3. Restart the server.
1.5.4 Configuring the IOC-0210-54 adapter card
To configure the IOC-0210-54 adapter card, contact your IBM SSR or see the
IBM Enterprise Storage Server Web Interface User's Guide.
xSeries and NUMA-Q System Element Requirement
PTX operating system Version 4.5.2 or higher
NUMA-Q and xSeries hardware models All NUMA-Q and xSeries Quad-based systems
Fibre Channel host adapter Emulex LP7000E with firmware SF 3.2.1
Fibre Channel switch IBM 2109 Model S08 or IBM 2109 Model S16
Clustered NUMA-Q and xSeries hosts ptx/Clusters V2.2.1