User`s guide

Chapter 4. Implementing the SAN Data Gateway 279
Figure 4-5 StorWatch SAN Data Gateway Specialist server
The client software can now be launched. If the server and client are not on the
same PC, then a dialog box will appear to allow you to enter in the IP address of
the computer that has the server software loaded. If the server and client are on
the same computer you will be automatically connected to this server. After
connection to the server is complete, a dialog box will appear, in which you can
enter in a user name and password.
The IBM Storage Area Network Data Gateway provides a default administrator:
򐂰 User Name: StorWatch
򐂰 Password: StorWatch
The fields are case sensitive, so they must be entered in as shown above.
A new administrator account should be set up by selecting Admin -> Add User
from the toolbar. After a new administrator account is created, then the default
user StorWatch is deactivated.
Note: If a new administrator account has been created, and the password is
lost, and no other account has administrator access, then you will have to
contact a service representative.