User`s guide

274 Implementing an Open IBM SAN
If a PC with terminal emulation is used, a 9-pin female to 9-pin female, null
modem cable is required and is provided with the unit.
Once connected, power on the SAN Data Gateway and the start up messages
will appear and scroll across the window. When the power on sequence has
completed, a prompt Gateway> appears on the window, as shown in
Figure 4-3.
Figure 4-3 IBM Storage Area Network Data Gateway startup
If you type in help and then press Enter, a list of available commands is
provided. The commands are case sensitive and
must be entered as they
appear.
Issue the initializeBox command to remove any configurations files that
may be present. The unit will restart automatically.
Note: The initializeBox command will erase all configuration files. It should
be used only during initial SAN Data Gateway installation.