User`s guide

Chapter 3. Implementing the INRANGE FC/9000 Fibre Channel Director 217
Figure 3-35 IN-VSN: Changing port names
We start with the two ports used for ESS attachment. Therefore, we change the
name of port 40 to ospl5b1p4 and port 48 to ospl5b4p4. Click Apply and confirm
this action to make the new names effective.
Then we repeat this procedure for all remaining server ports.
Note: Take into account that all the port names you have assigned refer to the
physical port of an INRANGE director. These names are technically
independent of any attached external ports.
However, we advise you to use port names that indicate which external ports
are actually attached or will be attached in the future. The port names can
later on be used for zoning purposes. In case of zoning, using a meaningful
port name will simplify the setup of zones. This is especially true for fabrics
that span multiple director and switch chassis.