Specifications

Installing the KZPBA-CB adapter card
The following procedures describe how to install the KZPBA-CB adapter card.
1. Shut down the Compaq AlphaServer host system.
2. Install the KZPBA-CB host bus adapter.
3. Restart the host (non-clustered configurations) or each cluster member
(clustered configurations).
4. Bring each host system to a halt condition at the console level.
5. On each AlphaServer console, execute a show config command to confirm that
you installed each adapter properly.
Figure 9 shows an example of what displays when you type show config. Note
the isp number of each adapter. Update the adapter firmware if required.
6. Type show device and note the Bus IDs shown for each isp.
See Figure 10 on page 23 for an example of what displays when you type show
device.
P00>>>show config
Name Type Ext Rev Mnemonic
TLSB
0++ KN7CH-AB 8025 0 0000 kn7ch-ab0
7+ MS7CC 5000 0 313043 ms7cc0
8+ KFTHA 2000 0 0D03 kftha0
C0 PCI connected to kftha0 pci0
3+ DEC PCI MC 181011 0 0022 mc0
4+ QLogic ISP1040B 10201077 0 0005 isp0
5+ DE600-AA 12298086 B1440E11 0008 ei0
6+ DE600-AA 12298086 B1440E11 0008 ei1
7+ QLogic ISP1040B 10201077 0 0005 isp1
8+ QLogic ISP1040B 10201077 0 0005 isp2
9+ KGPSA-C F80010DF F80010DF 0002 kgpsa0
A+ KGPSA-B F70010DF F70010DF 0004 kgpsa1
B+ QLogic ISP1040B 10201077 0 0005 isp3
P00>>>
Figure 9. Example of what is displayed when you type show config
22 ESS Host Systems Attachment Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|