Specifications

Configuring devices to mount automatically
To enable an AdvFS file system to start automatically, add an entry to the /etc/fstab
file that the mount command will issue during startup. Figure 8 shows an example
of a modified /etc/fstab file.
In Figure 8, the lines that are shown in bold type are the lines that were entered
since the initial operating system installation.
When the system starts, it mounts all the volumes that you created in “Configuring
AdvFS” on page 20.
Installing and Configuring Compaq Tru64 UNIX Version 5.x
Use the following procedures to install and configure the ESS disk drives on a
Compaq Tru64 UNIX Version 5.x.
Attachment considerations
See Table 7 for the maximum number of adapters you can have for an AlphaServer.
Table 7. Maximum number of adapters you can use for an AlphaServer
AlphaServer name Maximum number of adapters
800 2
1200 4
2100 4
4000, 4000a 4
4100 4
8200, 8400 8
DS10, DS20, DS20E 2
ES40 4
GS60, GS60E, GS140 8
Ensure that the console firmware level is v6.0-x or later. Ensure that you have the
following host bus adapter and firmware:
v KZPBA-CB (firmware rev. 5.57 or later)
Tru64 patch 399.00 Security (SSRT0700U) must be installed.
# root_domain#root / advfs rw,userquota,groupquota 0 0
/proc /proc procfs rw 0 0
usr_domain#usr /usr advfs rw,userquota,groupquota 0 0
/dev/rz8b swap1 ufs sw 0 2
vol1_dom#vol1 /vol1 advfs rw,userquota,groupquota 0 2
vol2_dom#vol1 /vol2 advfs rw,userquota,groupquota 0 2
vol3_dom#vol1 /vol3 advfs rw,userquota,groupquota 0 2
vol4_dom#vol1 /vol4 advfs rw,userquota,groupquota 0 2
vol5_dom#vol1 /vol5 advfs rw,userquota,groupquota 0 2
vol6_dom#vol1 /vol6 advfs rw,userquota,groupquota 0 2
vol7_dom#vol1 /vol7 advfs rw,userquota,groupquota 0 2
vol8_dom#vol1 /vol8 advfs rw,userquota,groupquota 0 2
vol9_dom#vol1 /vol9 advfs rw,userquota,groupquota 0 2
vol10_dom#vol1 /vol10 advfs rw,userquota,groupquota 0 2
Figure 8. Example of a modified /etc/fstab file
Chapter 2. Attaching to a Compaq host 21
|
|
|
|
|
|
|
||
||
||
||
||
||
||
||
||
||
|
|
|
|
|