Specifications

Table 22. Recommended configuration file parameters for the host bus adapters for the JNI
FC64-1063 and JNI FCI-1063. (continued)
Parameters Recommended settings
public loop 0: Default. Recommended. Initializes according to which fca_nport is
set as disabled.
ip_disable 0: Default. IP side of the driver is enabled.
1: Recommended for fabric. IP side of the adapters is completely
disabled.
failover 60: Recommend without the McData switch
300: Recommended with the McData switch
busy_retry_delay 500: Recommended. Delay between retries after device returns a
busy response for a command.
scsi_probe_delay 5000: Recommended. Delay before SCSI probes are allowed during
startup.
See Table 23 for recommended host bus adapter configuration file parameters for a
QLogic QLA2200F adapter. The settings in Table 23 are for an ESS Model F20 that
is either attached directly or through a fabric switch.
Table 23. Recommended configuration file parameters for the host bus adapters for the
QLogic QLA2200F adapter
Parameters Recommended settings
hba0-max-frame-length =2048;
hba0-max-iocb-allocation =256;
hba0-execution-throttle =31;
hba0-login-timeout =4;
hba0-login-retry-count =1;
hba0-fabric-retry-count =10;
hba0-enable-adapter-hard-loop- =0;
hba0-adapter-hard-loop-I =0;
hba0-enable-64bit-addressing =0;
hba0-enable-LIP-reset =0;
hba0-enable-LIP-full-login =1;
hba0-enable-target-reset
=0: non-clustered
=1: clustered
hba0-reset-delay =5;
hba0-port-down-retry-count =30;
hba0-link-down-error =1;
hba0-loop-down-timeout =60;
hba0-connection-options
=1: fabric connection
=2: direct connection
hba0-device-configuration-mode =1;
hba0-fc-tape =0;
hba0-command-completion-option =1;
116 ESS Host Systems Attachment Guide