Specifications

Note: If you are installing the fibre-channel adapter for the first time, you must
specify the correct topology. You must also select the appropriate device
mapping driver.
1. Go to the following Web site:
www.qlogic.com
2. From the home page, click Driver Download.
3. Click Use QLogic Drivers button.
4. Click Fibre Channel Adapter Drivers and Software.
5. In the table for QLogic Fibre Channel Adapters, click QLA22xx.
6. From the Software and Drivers available menu, click Solaris.
7. From the table for QLA22xx Driver Download Page, Solaris Sparc 2.6/2.7/2.8,
and Current released (Sparc) driver PCI to FC Adapter, click Read Me.
This action displays the contents of the README file, which contains the
instructions to install the driver file.
Configuring host device drivers
Perform the following steps to update the Solaris SCSI driver configuration file. This
gives you to access to target and LUN pairs that are configured on the ESS.
1. Change to the directory by typing: cd /kernel/drv
2. Backup the sd.conf file in this subdirectory.
3. Edit the sd.conf file to add support for the target and LUN pairs that are
configured on the host system. Figure 55 on page 113 shows the lines that you
would add to the file to access LUNs0-7ontarget 0 for SCSI.
Note: Do not add duplicate target and LUN pairs.
112 ESS Host Systems Attachment Guide
|
|
|
|
|