Specifications

Installing the adapter drivers
Perform the following steps to install the fibre-channel adapter drivers:
1. From the NetWare server console, type nwconfig for NetWare 5.0 or 5.1 or
load install for NetWare 4.x.
2. Select Driver Options.
3. Select Configure Disk and Storage Device Drivers.
4. In the SCSI Adapters window, click the Drivers tab.
5. Select Select an additional driver.
6. Press the Insert key.
7. Insert a floppy diskette with the QLogic drivers into the A:\ drive of the
NetWare server. Press Enter.
The available driver is displayed.
8. Select the driver for the QLogic card, and press Enter.
9. Select Select/Modify driver parameters and type the slot number of the
QLogic card into the slot number parameter.
10. Set the Scan All LUNs parameter to Yes.
11. Press the Tab key and check Save Parameters and Load Driver.
12. Type exit to exit the nwconfig or install utility.
13. If storage has already been assigned to the server from the ESS Specialist,
type Scan for all new devices, Scan all LUNs, and List devices.
The ESS volumes are displayed in the devices list. Create volumes using the
nwconfig utility if necessary.
Configuring the QLogic QLA2100F or QLA2200F adapter card
To configure the adapter card, use the IBM Enterprise Storage Server StorWatch
Specialist.
Chapter 9. Attaching to a Novell NetWare host 97