Specifications

9. To save the changes, click Yes. Press Enter.
10. Restart the server.
Installing the QLogic QLA2200F adapter card
This section tells you how to attach an ESS to a Novell NetWare host system with
the QLogic QLA2200F adapter card. Single- and dual-port fibre-channel interfaces
with the QLogic QLA2200F adapter card support the following public and private
loop modes:
v Target
v Public initiator
v Private initiator
v Target and public initiator
v Target and private initiator
Perform the following steps to install the QLogic QLA2200F adapter card.
Note: The following steps are an example of a configuration. The configuration for
your adapter might differ.
1. Install the QLogic QLA2200F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the server.
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, click Host Adapter Settings.
Set the parameters and values from the Host Adapter Settings menu as
follows:
a. Host adapter BIOS: Disabled
b. Frame size: 2048
c. Loop reset delay: 5 (minimum)
d. Adapter hard loop ID: Disabled
6. From the Advanced Adapter Settings menu, press the Down Arrow key to
highlight LUNs per target; then press Enter. Set the parameters and values
from the Advanced Adapter Settings menu as follows:
a. Execution throttle: 240
b. Fast command posting: Enabled
c. >4 GB addressing: Disabled for 32 bit systems
d. LUNs per target: 32
e. Enable LIP reset: No
f. Enable LIP full login: No
g. Enable target reset: Yes
h. Login retry count: 20 (minimum)
i. Port down retry count: 20 (minimum)
j. Driver load RISC code: Enabled
k. Enable database updates: No
l. Disable database load: No
m. IOCB allocation: 256
n. Extended error logging: Disabled (might be enabled for debugging)
7. Press Esc to return to the Configuration Settings menu.
Chapter 9. Attaching to a Novell NetWare host 95