Specifications

SCAN ALL LUNS
Note: This enables the server to scan all the attached storage before
mounting the volumes.
11. Save the file.
12. Restart the server.
13. At the system console, type the following commands:
SCAN FOR NEW DEVICES
LIST DEVICES
A list of all the devices is displayed.
14. Partition the devices and make volume groups.
Attaching with fibre-channel adapters
This section describes how to attach an ESS to a Novell NetWare host system with
the following adapter cards:
v QLogic QLA2100F
v QLogic QLA2200F
Note: The IBM SAN Fibre Channel Switch 2109 Models S08 and S16 are
supported for Novell NetWare. The IBM SAN Data Gateway 2108 Model G07
is not supported for Novell NetWare.
For procedures about how to attach an ESS to a Novell NetWare host system with
SCSI adapters, see “Attaching with SCSI adapters” on page 91.
Installing the QLogic QLA2100F adapter card
This section tells you how to attach an ESS to a Novell NetWare host system with
the QLogic QLA2100F adapter card. Single-port fibre-channel interfaces with the
QLogic QLA2100F adapter card support the following loop modes:
v Target
v Initiator
v Target and initiator
Note: The arbitrated loop topology is the only topology available for the QLogic
QLA2100F adapter card.
Perform the following steps to install the QLogic QLA2100F adapter card.
Note: The following steps are an example of a configuration. The configuration for
your adapter might differ.
1. Install the QLogic QLA2100F adapter card in the host system.
2. Connect the cable to the ESS port.
3. Restart the server.
4. Press Alt+Q to get to the FAST!Util menu.
5. From the Configuration Settings menu, click Host Adapter Settings.
6. From the Advanced Adapter Settings menu, press the Down Arrow to
highlight LUNs per target. Press Enter.
7. Press the Down Arrow to find and highlight 32. Press Enter.
8. Press Esc.
94 ESS Host Systems Attachment Guide