Installation guide

Installation Help 2 – Hardware Installation

2-6 FC0151102-00 D

If the information displayed on your monitor is correct (all installed devices are

listed), congratulations! You have successfully installed the QLA2xxx board in

your computer.

See the appropriate QLogic software installation guide for detailed instructions on

how to install the software drivers.

If the information displayed is not correct and you have checked the QLA2xxx

board’s conﬁguration, see section 3 for troubleshooting information.

2.5

Installation Help

If your system has an integrated drive electronics (IDE) ﬁxed disk device, it is

assigned device number 80 and is the boot device. If your system does not have an

IDE disk device, the ﬁrst bootable FC disk device conﬁgured (the one with the

lowest ID) is assigned device number 80 and is the boot device.

If you do not have an IDE disk device, set the motherboard BIOS parameters to

None or Not Installed. The ROM BIOS on the FC controller automatically

conﬁgures the FC peripherals.