Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
9
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Arbitrated Loop Configurations
c. Scroll to the bottom of the Qlogic Drivers License Agreement
and click Use Qlogic Drivers/Software.
d. Click EMC Approved Drivers.
e. Click EMC Approved QLA22xx Drivers.
f. Click Link to ROM BIOS in the ROM BIOS v1.59 section.
g. Save the file as c:\22emc03bios159.zip.
2. The file is a self-extracting ZIP file that must be extracted to a
bootable diskette drive, as follows:
a. Open any DOS window.
b. At the DOS prompt, type
cd \ ENTER, to go to the root
directory.
c. Type 22emc03bios159 a: ENTER.
Upgrade the BIOS
After the QLA2200-EMC HBA is installed in an EMC-qualified host,
complete the following steps to upgrade the HBA BIOS:
1. Insert the BIOS upgrade installation diskette into the diskette
drive.
2. Reboot the host.
3. After the host has rebooted, a DOS prompt appears. Type
Ql2xutil /L /F ENTER.
The HBA BIOS upgrade might take a few minutes.
4. After the upgrade is complete, remove the diskette and reboot the
host. During boot-up, the QLA2200F banner (see Figure 1 on
page 7) should display BIOS Version 1.59.