Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
4
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Arbitrated Loop Configurations
Arbitrated Loop Configurations
UnixWare 7 FC-AL
Environment
This section lists some general Symmetrix Fibre Channel support
information specific to arbitrated loop in a UnixWare 7 host
environment.
Host Operating
System
For the latest information, refer to the chapter on SCO UnixWare 7
Host on Arbitrated Loop in the Symmetrix Fibre Channel Product Guide
(200-999-642), rev D, or contact your EMC representative.
Software Patches For EMC-qualified patch configuration, see your EMC customer
representative.
Boot Device Support Symmetrix devices interfaced through Fibre Channel are not
supported as boot devices for SCO UnixWare 7 hosts.
Hub Support Hubs are not supported.
Addressing If you attempt to access existing devices previously interfaced via
SCSI, your raw device addressing might be changed after upgrading
to Fibre Channel Directors.