Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
3
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Introduction
Introduction
This document describes the procedures for installing a Qlogic
QLA2200F-EMC host bus adapter (HBA) into an SCO
®
UnixWare 7 ™
host and configuring the host for connection to EMC
®
Symmetrix
®
over Fibre Channel arbitrated loop or fabric.
Check the EMC Host Support Matrix for the latest information on
approved HBAs and drivers.
This document includes the following sections:
• Arbitrated Loop Configurations on page 4 — Contains steps that are
required to install a QLA2200F-EMC HBA into a UnixWare 7 host
that will connect to Symmetrix over Fibre Channel arbitrated
loop.
• Fabric Configurations on page 17 — Contains steps that are
required to install a QLA2200F-EMC HBA into a UnixWare 7 host
that will connect to Symmetrix over Fibre Channel fabric.