Product guide

Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7

Fabric Configurations

7. After media verification has completed:

• If the message

Media Verification Complete appears, press

ESC repeatedly to exit Fast!Util and reboot the host, then

continue with Installing the HBA Driver on page 11.

• If the media verification fails, verify:

✦ that the cables and connectors are not damaged.

✦ that the host has been rebooted since the last HBA BIOS

change.

Install the HBA Driver Setup Checklist step 6

The SCO Unixware 7 operating system interface to the Symmetrix

Fibre Channel director requires HBA driver software. The driver

functions at a layer below the Unixware 7 SCSI driver to present Fibre

Channel devices to the operating system as if they were standard

SCSI devices. The driver is in a disk image format and must be copied

to a diskette before driver installation.

Obtaining the Latest

HBA Driver

Setup Checklist step 6a

Be sure you have the latest qualified driver software. This is available

on the Qlogic website or the EMC-released CD-ROM:

To copy the EMC-approved driver from the release media:

1. Insert the CD-ROM into the UnixWare 7 host.

2. Issue the following command to mount the CD-ROM:

Mount -F cdfs -oro /dev/cdrom/cdrom1 /mnt ENTER

3. Type cd /mnt/cdrom/qlogic/sco ENTER, to go to the proper

driver directory on the CD.

4. Type

cp qlc2200.Z /tmp ENTER, to copy the driver to the /tmp

directory.

To obtain the EMC-approved driver from the Qlogic Web site:

1. Access http://www/qlogic.com.

2. Click Driver Downloads.

3. Scroll to the bottom of the Qlogic Drivers License Agreement and

click Use Qlogic Drivers.

4. Click EMC Approved Drivers.

5. Click SCO UnixWare 7.1.1 Driver.