Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
26
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Fabric Configurations
Upgrade the BIOS:
After the QLA2200-EMC HBA is installed in an EMC-qualified host,
complete the following steps to upgrade the HBA BIOS:
1. Insert the BIOS upgrade installation diskette into the diskette
drive.
2. Reboot the host.
3. After the host has rebooted, a DOS prompt appears. Type
Ql2xutil /L /F ENTER.
The HBA BIOS upgrade might take a few minutes.
4. After the upgrade is complete, remove the diskette and reboot the
host. During boot-up, the QLA2200F banner (see Figure 2 on
page 23) should display BIOS Version 1.59.