Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
20
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Fabric Configurations
11. Modify the Qlogic file space.c with binding information obtained from osmlog,
enable persistent binding, flag and verify all other driver variables. Then rebuild
the kernel and reboot.
a. Refer to Configuring and Enabling Persistent Binding on page 38.
b. Refer to Other Driver Variables on page 39.
c. Refer to Rebuilding the Kernel on page 39.
12. After steps 1 through 6 are complete and the system has been rebooted, you will
be able to see all Symmetrix raw devices in the /dev/rdsk/ directory.
n/a
a. To see all targets and LUNs in the Symmetrix configuration, use the
ls /dev/rdsk/*s0 command. You can also view Symmetrix devices by
issuing the /sbin/sdiconfig -1 command.
13. If any problems are encountered during installation or normal operation, refer to
Troubleshooting on page 40.
Step Done?