Product guide
Table Of Contents
- Introduction
- Arbitrated Loop Configurations
- Fabric Configurations
- UnixWare 7 Fabric Environment
- Setup Checklist
- Verifying Symmetrix Configuration
- Verifying and Updating HBA BIOS-Level Configurations
- Scanning for the Symmetrix on an HBA BIOS Level
- Install the HBA Driver
- Changing System Configuration File Settings
- UnixWare 7 Conventions and Persistent Binding Information
- Beware of Ghost Names
- Configuring and Enabling Persistent Binding
- Troubleshooting
17
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Fabric Configurations
Fabric Configurations
UnixWare 7 Fabric
Environment
This section lists some general Symmetrix Fibre Channel support
information specific to fabric in a UnixWare 7 host environment.
Host Operating
System
For the latest information, refer to the chapter on SCO UnixWare 7
Host on Fabric in the Symmetrix Fibre Channel Product Guide
(200-999-642), rev D, or contact your EMC representative.
Software Patches For EMC-qualified patch configuration, see your EMC customer
representative.
Boot Device Support Symmetrix devices interfaced through Fibre Channel are not
supported as boot devices for SCO UnixWare 7 hosts.