Product guide

11
Symmetrix Fibre Channel with Qlogic HBAs on UnixWare 7
Arbitrated Loop Configurations
7. After media verification has completed:
• If the message
Media Verification Complete appears, press
ESC repeatedly to exit Fast!Util and reboot the host, then
continue with Installing the HBA Driver later on this page.
• If the media verification fails, verify:
> that the Hard Loop IDs are unique between the host bus
adapter and the Symmetrix.
> that the cables and connectors are not damaged.
> that the host has been rebooted since the BIOS settings
were changed.
Installing the HBA
Driver
Setup Checklist step 5
To ensure seamless operation between the SCO Unixware 7 host and
the Symmetrix while using a QLA2200F-EMC HBA, only an
EMC-approved QLA2200 driver should be installed.
Obtaining the Latest
Driver
Setup Checklist step 5a
Be sure you have the latest qualified driver software. This is available
on the Qlogic website or the EMC-released CD-ROM:
To copy the EMC-approved driver from the release media:
1. Insert the CD-ROM into the UnixWare 7 host.
2. Issue the following command to mount the CD-ROM:
Mount -F cdfs -oro /dev/cdrom/cdrom1 /mnt ENTER
3. Type cd /mnt/cdrom/qlogic/sco ENTER, to go to the proper
driver directory on the CD.
4. Type cp qlc2200.Z /tmp ENTER, to copy the driver to the /tmp
directory.
To obtain the EMC-approved driver from the Qlogic Web site:
1. Access http://www/qlogic.com.
2. Click Driver Downloads.
3. Scroll to the bottom of the Qlogic Drivers License Agreement and
click Use Qlogic Drivers/Software.
4. Click EMC Approved Drivers.