Installation guide

2 – UnixWare Driver Installation Installing the UnixWare Driver
FC0153301-00 D 2-3
3. The following prompt appears:
Insert diskette into Floppy Drive 1.
Type [go] when ready,
or [q] to quit: (default: go)
4. Insert the diskette that contains the QLogic driver into drive 1 and press
<ENTER> to select [go].
5. You are prompted to select a driver package. For example:
Installation in progress. Do not remove the
diskette.
The following packages are available:
1 qlc2100 QLogic QLA2100/2100F IHV HBA
(i386) 3.11
Select packages(s) you wish to process (or ’all’
to process all packages). (default: all)
[?,??,quit]:
6. Type 1 and press <ENTER> to install the qlc2100 driver.
7. When the driver is installed, the following prompt appears:
Installation of QLogic QLA2100/2100F IHV HBA
(qlc2100) was successful.
Insert diskette into Floppy Drive 1.
Type [go] when ready,
or [q] to quit: (default: go)
8. Type q and press <ENTER> to exit the installation program.
9. Remove the diskette that contains the QLogic driver.
10. Reboot the system to load the driver.