Installation guide

FC0153301-00 D 2-1
Section 2
UnixWare Driver Installation
(qlc2100)
2.1
Introduction
This section provides instructions for installing the UnixWare driver under the
following operating system conditions:
❑ Initial installation of UnixWare 2.1 or 7 and the UnixWare driver
❑ Installation of the UnixWare driver in an already installed UnixWare 2.1
or 7 system
If UnixWare 2.1 or 7 is not installed on your system, perform the installation
procedures in section 2.2 or 2.3. If Unixware 2.1 or 7 is already installed, perform
the installation procedures in section 2.4.
The latest version of the UnixWare driver package is available on the QLogic web
site for UnixWare 2.1 and 7. The files in the driver package cannot be read nor
installed from a DOS environment. Be sure to review the installation and/or release
notes for both new and changed information.
The installation of host adapter boards and devices is covered in detail in the
UnixWare documentation. See the following topics for more information.
❑ Using boot-time loadable drivers (Installation Guide)
❑ Adding hard disks and CD-ROM drives (System Administrator’s Guide)
2.2
Initial Installation of UnixWare 2.1 and the UnixWare Driver
Perform the following steps to install UnixWare 2.1 and the qlc2100 driver.
1. Follow the installation instructions that come with the UnixWare 2.1
installation diskettes. During the installation, you will be prompted to
install the driver for the QLA2xxx board.
When installing UnixWare 2.1, the following choices appear (the asterisk
is the system default):
(*) Install Host Bus Adapter Drivers
( ) Continue Installation