Installation guide

Windows NT Installation 4 – Windows NT Driver Installation
4-2 FC0153301-00 D
4.3.1
Initial Installation of Windows NT and the Windows NT Driver
Perform the following steps to install Windows NT 4.0 on the Fibre Channel drive
attached to the QLA2xxx board.
1. Place the Windows NT setup diskette in an appropriate drive.
2. Reboot your system.
3. Follow the standard Windows NT installation instructions.
4. Once the standard devices have been detected and configured, select
Specify Additional Device.
5. Select Other, then press <ENTER>.
6. Insert the diskette that contains the QLogic driver into an appropriate disk
drive, then press <ENTER>.
7. Windows NT detects the QLogic QLA2000/QLA2100, PCI-Fibre Channel
Adapter. Press <ENTER> to continue the driver installation.
8. Follow the standard Windows NT installation instructions to complete the
Windows NT setup.
4.3.2
Installing the Windows NT Driver
Perform the following steps to add the Windows NT driver to a previously installed
Windows NT 4.0 system.
NOTE: This procedure restores the default Registry parameters for the QLA2xxx
Windows NT driver.
1. Select My Computer from the desktop.
2. Select Control Panel.
3. Select SCSI Adapters.
4. Select the Drivers tab and click Add.
5. Insert the diskette that contains the QLogic driver into an appropriate drive
and click Have Disk.
6. Type the path to the Windows NT driver on the diskette. For example:
A:\NT
7. Click OK.