User`s guide

5–Fibre Channel Noninteractive Commands
-p (Display Persistent Target Binding Info)
SN0054667-00 B 5-29
To show target persistent binding information for a specific adapter port, issue the
following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (view | info)
To show persistent binding information for all adapters, issue the following
command:
# qaucli -pr fc -p all (view | info)
Where:
The following example is a typical QConvergeConsole CLI output showing all
targets currently bound to an adapter:
--------------------------------------------------------------------------
HBA 0: QLA2462 Port 1 WWPN xx-xx-xx-xx-xx-xx-xx-xx Port ID 11-06-EF
--------------------------------------------------------------------------
Bind Type Device Node Name Device Port Name Port ID ID
---- ---- ---------------- ---------------- ------- --
No Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E1
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E2 0
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-
xx-xx-xx-xx-xx 10-02-E4 1
Yes Disk xx-xx-xx-xx-xx-xx-xx-xx xx-xx-xx-xx-xx-xx-xx-xx 10-02-E8 2
Press <Enter> to continue:
To bind a selected target to a specific adapter, issue the following command:
# qaucli -pr fc -p (<hba instance> | <hba wwpn>) (<target wwnn>
<target wwpn> <target port id> <target id>)
Where:
NOTE:
Under Linux, if you use the IOCTL or sysfs (inbox) driver these features are
disabled.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
hba instance = Adapter number (use -g command to find)
hba wwnn = Word wide node name of the adapter
hba wwpn = World wide port name of the adapter
target wwnn = World wide node name of the target
target wwpn = World wide port name of the target