User`s guide

5–Fibre Channel Noninteractive Commands
-n (Set Selected HBA Parameter)
5-26 SN0054667-00 B
To disable (deselect) all LUNs for a specific target on a specific adapter, issue the
following command:
# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect | disable
<target wwnn> <target wwpn>
To enable (select) all LUNs of all targets on a specific adapter:
# qaucli -pr fc -m (<hba instance> | <hba wwpn>) select all
To disable (deselect) all LUNs of all targets on a specific adapter:
# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect all
-n
(Set Selected HBA Parameter)
To set a specific parameter on a specific adapter, issue the following command:
# qaucli -pr fc -n (<hba instance> | <hba wwpn>) { (<param name> |
<param alias>) <param value>}
To restore the default BIOS (4G adapters only), issue the following command:
# qaucli -pr fc -n (<hba instance> | <hba wwpn>) default
Where:
The pairs <param name> <param value> and <param alias> <param value> can
be repeated to set multiple parameters with a single command.
Table 5-9 lists the adapter parameter names and aliases.
.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters
Table 5-9. Adapter Parameters
Description Name Alias Value
Connection options ConnectionOption CO
See table note
a
Data rate DataRate DR
See table note
b
Enable BIOS
EnableBIOS
c
EB 1=Enable, 0=Disable
Enable extended logging EnableExtendedLog-
ging
d
EL 1=Enable, 0=Disable