User`s guide

4–NIC Noninteractive Commands
-intloopback (Configure Test Parameters)
SN0054667-00 B 4-7
For example:
> qaucli -pr nic -idcbx 1
--------------------------------
DCBX
--------------------------------
DCBX Enable : Enabled
DCBX Negotiation : Successful
Port Pause Type : Per Priority Pause
--------------------------------
ETS
--------------------------------
Priority Tx Mode : Bandwidth
SAN Unused BW to LAN : Disabled
LAN Unused BW to SAN : Enabled
Class 1 Priority Group ID : 1
Class 1 Bandwidth Percent : 1
Class 1 CoS Priorities : 3
Class 2 Priority Group ID : 2
Class 2 Bandwidth Percent : 99
Class 2 CoS Priorities : 0 1 2 4 5 6 7
-intloopback
(Configure Test Parameters)
To configure loopback test parameters before you run the test, issue the
intloopback command as follows:
> qaucli -pr nic -intloopback <cna_port_inst> <tests_num>
<on_error>
Where tests_num specifies the number of tests to run (a value between 1 and
65,535) and on_error specifies the action to take if an error is encountered in
the test (0 = ignore the error; 1 = abort the test).
NOTE:
An external loopback test requires the installation of a loopback plug in the
port SFP.