User`s guide

4–NIC Noninteractive Commands
-d
4-4 SN0054667-00 B
For example:
> qaucli -pr nic -ch 1
=== Displaying CNA config info for 1. CNA Port Index ===
CNA_Alias : CNA X54
-d
To generate XML discovery output, issue the -d command as follows:
> qaucli -pr nic -d <flash_file> [xml_output_file]
where flash_file is the Flash file and xml_output_file is the XML
discovery output. If you omit xml_output_file, XML discovery output is written
to stdout.xml.
-ei
To get about error and exit code information for noninteractive mode, issue the -ei
command as follows:
> qaucli -pr nic -ei
-extloopback
To configure external loopback test parameters before you run the test, issue the
intloopback command as follows:
> qaucli -pr nic -extloopback <cna_port_inst> <tests_num>
<on_error>
Where tests_num specifies the number of tests to run (a value between 1 and
65,535) and on_error specifies the action to take if an error is encountered in
the test (0 = ignore the error; 1 = abort the test).
-g
(Display General System Information)
To view general system information for the host, issue the -g command as
follows:
> qaucli -pr nic -g [cna_port_inst]